Print

[Dasoldier]

I'm going off of this tutorial...  
http://forums.xbox-scene.com/index.php?act...ST&f=43&t=48213

http://www.lone.net/xbox/Dual_Boot_TSOP_Guide.pdf

and am I understanding this correctly,  I just solder 3 wires from the 3 points to this switch.   Do I just follow the pictures in this tutorial http://www.lone.net/xbox/Dual_Boot_TSOP_Guide.pdf               and use A19, Then the red Circle that isn't marked 18 or 19 is the ground  correct? (and if so where exactly on that do I solder)?, and the picture below it is that the vcc point I solder to?  

 My write for the bios is already enabled from the first time I flashed my TSOP.    and is there a better picture showing exactly what 3 to solder to?   How do I know what my original bios was or does it make a difference?

Just wanting to make sure so I don't screw anything up.

This post has been edited by Dasoldier: Dec 29 2003, 12:11 AM