Your answer is right here in my previous reply " if you go to site manager and go to advanced for your xbox ftp connection you can select whether to use passive, active or default modes". Plus WHAT DASH ARE YOU USING. cause it makes a difference as to what mode you SHOULD use.
I use Avalaunch. But still "passive mode" and "NOT PASV" is two different things, at least in FlashFXP it is, check it out yourself here:
As you can see "NOT PASV" and "Passive mode" is two different things. I need to run this "NOT PASV", to be able to run the FXP protocol, there's something about it here:
I had the problem of getting quite slow speeds uploading and downloading to my Xbox.
Usually I got only 2-3 Mb/sec, sometimes only 100-200k !!
The tutorial below
describes how to fix this using the FXP protocol and the build in FTP server in EvolutionX.
Best physical connection to use is a good (CAT5) crosslink cable, but a hub or switch should work fine too, make sure they can handle 100Mbit network speed of course
The solution is to use the FXP protocol instead of the FTP protocol to transfer the data from and to your PC.FXP is a protocol that makes it possible to send data from server to server, also known as the server to server protocol.
First you've got to set up a FTP server on your pc, I prefer using Serv-U FTP because it is easy to use
It can be downloaded here:
http://www.serv-u.comNext we've got to set up an account here, follow the 'getting started' guide by clicking help if you're not familiar with this program.
Now we've got to make a little change in the default Flashfxp settings
The connection to Home FTP can have all default flashfxp settings,
for the XBOX connection weve got to select the alternative (FXP) method to NOT PASV (see picture below).
Hope you or somebody can help me after these infos.